Microbit RRC-1258 MkII(s) Manual do Utilizador descarregar pdf (Página 26)

USER MANUAL

m crob t

RRC-1258 MKII

Ba1258B_RemoteRig_MkIIs-A33.docx

User manual

Rev. A33 – 2015 Jan 28

26 of 236

Configuration with Microbit Setup Manager

The initial settings of the network parameters are easiest done with the Microbit Setup

Manager. The Setup Manager is a software which runs under Windows on a PC and connects

to the RRC via USB (an USB cable is supplied with the RRC). The Setup Manager can be used

for:

 IP Settings and verification

o IP-address

o Netmask

o Gateway

o DNS

o DHCP

 Firmware upgrade

o Application

o Bootloader

 Changing profile

 Scanning for WiFi networks and WiFi setup.

Start with downloading the Microbit Setup Manager from the homepage www.remoterig.com.

Install the Microbit Setup Manager by following the instructions which shows up. If you have

an old version of Windows XP where Netframework 2.0 is not installed, you have to install

Netframework from Microsoft before installing the Setup Manager. When you have finished

the installation a new shortcut to the Setup Manager will show up on the desktop. Click on the

icon to start Setup Manager

Initial IP setup via LAN

Do not install any WiFi cards yet. Connect both your RRC:s to 12V and connect both to the

same Ethernet switch or router as your configuring PC is connected to.

To do the Initial IP setup over the LAN a RRC firmware version from v2.79 or later are

required. If you install a new set of RRC:s this is no problem but if you have a set of used

RRC:s you may need to use USB to first upgrade them to the latest firmware ( see chapter

about USB configuration).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 235 236

Microbit RRC-1258 MkII(s) Manual do Utilizador Página 26