Microbit RRC-1258 MkII(s) Manual do Utilizador descarregar pdf (Página 19)

USER MANUAL

m crob t

RRC-1258 MKII

Ba1258B_RemoteRig_MkIIs-A33.docx

User manual

Rev. A33 – 2015 Jan 28

19 of 236

Pin no

PWR

+ 10-18 VDC (centre)

GND

RESET

A short press on the reset switch will reboot the unit. By pressing and keep the button

pressed for 20 sec the unit reset to factory default settings with the following network

settings:

Control-RRC IP-address: 192.168.0.227

Radio-RRC IP-address: 192.168.0.228

Netmask: 255.255.255.0

Gateway: 192.168.0.1

DNS: 192.168.0.1

I/O

In the I/O connector is 3(2) inputs and 3 outputs, 8V and GND available (see below). The

connector is used for transferring signals from one RRC to the other. If the CW-keyer function

is not used the connector can be used for whatever controls signals needed in both directions.

The output transistor can sink max 200mA so install an external relay if it's not strong

enough.

Pin no

I/O (RJ45)

IN1, active low (CW-Keyer right-paddle)

IN2, active low (CW-Keyer left-paddle)

OUT2, open collector (parallell with PAD Tip at Radio-RRC)

IN0, active low (only available at Control-RRC)

OUT0 open collector

OUT1 open collector (parallell with PAD Ring at Radio-RRC)

8V OUT (max 100mA)

GND

12V DC

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 235 236

Sem comentários

Microbit RRC-1258 MkII(s) Manual do Utilizador Página 19