Microbit RRC-1258 MkII(s) Manual do Utilizador descarregar pdf (Página 164)

USER MANUAL

m crob t

RRC-1258 MKII

Ba1258B_RemoteRig_MkIIs-A33.docx

User manual

Rev. A33 – 2015 Jan 28

164 of 236

Connections

The cabling is quite simple and can be done with simple RJ and modular connectors. The 6

wire control cables are the same on control and radio end. Drawings of the connection cables

can be found below.

Control-RRC:

 The control cable Y10a should be connected between the Control panel and the AUX/MIC

connector.

 The original microphone should be connected direct to the radio front panel as usual.

 A speaker is connected direct to the RRC SP-jack with a 3.5 mm stereo plug.

Radio-RRC:

 The control cable Y10a should be connected between the Radio-RRC AUX/MIC jack and the

Radio.

 The speaker cable (Y10c) eg. a standard cable with 3.5 mm mono connectors in both ends

should be connected between the radio and the Radio-RRC speaker jack. If a cable with

stereo plugs are used the ring must be connected to GND in the Radio end otherwise the

radio will not sense that a speaker is connected.

Power supply

Control-RRC:

The Control-RRC is supplied with a common 13,8 V (10-18V) power supply. The display and

speaker amplifier needs a lot of power so you need 1A.

Radio-RRC:

The Radio-RRC should be supplied from the same power supply as the radio to avoid

humming. Please put a small fuse on the cable if you connect it to a 30 Amp PS.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 235 236

Sem comentários

Microbit RRC-1258 MkII(s) Manual do Utilizador Página 164