
Ba1258B_RemoteRig_MkIIs-A33.docx
Microbit 2.0 AB 2010. All rights reserved
Radio settings (example)
(*) Available only in RRC-1258MkIIs, remember that the bandwidth demand is doubled.
Connections
The TS-2000 is quite simple to connect because you do not need any special cable. All
necessary signals between the panel and the radio are connected with the 4 wires in the
connection cable. We just need to cut it apart and connect a RRC-1258MkII in each end. The
following signals are represented in the connection cable (modular):
RJxx
Modular 4/4
Control panel
8V power to control panel (always present)
RDO - serial data 57600 bps from radio to panel
TDO - serial data 57600 bps from panel to radio
The easiest way to make these two cables from control panel to Control-RRC TTL connector
and from Radio-RRC TTL connector to radio is to cut the cable supplied by Kenwood into two
pieces. You only have to crimp two new 4/6 modular connectors on the cables. Don't make
the one between Radio-RRC and radio to long.
The long microphone extension cable supplied by Kenwood can also be used between Radio-
RRC AUX/MIC connector to the radio Microphone jack. Probably you need to cut it later to
prevent it from picking up HF from your antennas.
The microphone can be connected to the Control-RRC AUX/MIC connector using the adapter
cable MJ-88 supplied by Kenwood with your TS-2000.
Comentários a estes Manuais