Microbit RRC-1258 MkII(s) Manual do Utilizador Página 112

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 236
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 111
USER MANUAL
m crob t
RRC-1258 MKII
Ba1258B_RemoteRig_MkIIs-A33.docx
Microbit 2.0 AB 2010. All rights reserved
a
User manual
Rev. A33 2015 Jan 28
112 of 236
Radio settings (example)
Parameter
Control
Radio
Program mode
2 IC706
2 IC706
SIP password
hello
hello
SIP contact
192.168.0.228
Auto connect
No
Audio quality
2 Linear 16 bits 8 kHz
2 Linear 16 bits 8 kHz
Audio dual-rx (*)
No
Codec out gain
255
255
Codec inp gain
18
0
Codec inp preamp
Yes
Codec inp HPF Hz
163
163
COM0 baudrate
19200
19200
COM0 data bits
8
8
COM0 stop bits
1
1
COM0 parity
0 - Off
0 - Off
(*) Available only in RRC-1258MkIIs.
Connections
All necessary signals between the panel and the radio are connected with the 8 wires in the
cable OPC-581 or OPC-587 from ICOM. We just need to cut it apart and connect a RRC-
1258MkII in each end. The following signals are represented in the cable, (the numbering is
for the RJ45 connector to the RRC after converting the cable, not for the ICOM connector):
1 8V power to control panel (only when radio is ON)
2 LRXD - serial data 19200 bps from panel to radio
3 AF - audio to speaker.
4 PWK - power control, grounding it switch on the radio
5 MICE - mic ground
6 MIC- mic Signal
7 GND
8 LTXD - serial data 19200 bps from radio to panel
Cut the ICOM cable (OPC-581 or OPC-587) and connect both ends to a standard CAT-5 patch
cable for computer networks, use shrinking tubes to protect the soldering. One problem is
that the ICOM cable is very soft and there is more sewing tread than copper wire. The copper
wire is also varnished to make it even more difficult. Before you connect the cables to the
RRC:s, please check the cables by connecting them together with a 2xRJ45 connector. Also
pay attention to that a speaker or headset must be connected to the speaker jack on the IC-
706 front-panel otherwise the no audio will be sent from the microphone to the radio.
Vista de página 111
1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 235 236

Comentários a estes Manuais

Sem comentários